RPP Hobby Blog

Navigation Menu

Axial SCX10 II Build – Part 7

Axial SCX10 II Build – Part 7

Posted by on May 10, 2017 in Tech | 0 comments

Welcome to the final installment of our Axial SCX10 II kit build. Now that we have a functioning scale R/C vehicle, all we need is some paint to bring that classic Jeep Cherokee body to life. In this article we will cover trimming, painting, and detailing the Lexan body. We planned to keep the paint fairly simple since we want it to look like a Jeep you...

Read More

Tamiya Grand Hauler Kit Build – Part 3

Tamiya Grand Hauler Kit Build – Part 3

Posted by on Apr 27, 2017 in Tech | 0 comments

It’s time for part 3 of our Tamiya Grand Hauler kit build. For the first two installments of this build, we covered chassis and axle assembly. In this portion of the build, we will cover installing the rear axles and dig into the amazing three speed transmission that comes with this kit. It doesn’t get much cooler than being able to shift gears...

Read More

Axial SCX10 II Build – Part 6

Axial SCX10 II Build – Part 6

Posted by on Mar 23, 2017 in Tech | 0 comments

It is officially time for part 6 of our Axial SCX10 II Kit build. Now that we pretty much have a rolling chassis it is time to install the electronic speed control, aka ESC. We will also plug in the receiver to finish out the electronics install. After that, we will be making an upgrade in the wheel and tire department to give our rig a little different...

Read More

Axial SCX10 II Build – Part 5

Axial SCX10 II Build – Part 5

Posted by on Mar 16, 2017 in Tech | 0 comments

Welcome to part 5 of our SCX10 II kit build! It has been a while since we have done a blog entry on the SCX10 II because of the two other builds we have going on. Now that we are back on this project here is where we are at. The axles, transmission and driveshafts were all completed in the first few blog entries. In this installment of our build we will...

Read More

Tamiya Grand Hauler Kit Build – Part 2

Tamiya Grand Hauler Kit Build – Part 2

Posted by on Mar 10, 2017 in Tech | 1 comment

Welcome to part two of our Tamiya Grand Hauler kit build. In part one we covered installing the shifting and steering servos, assembled the main chassis and started bolting on some of the suspension brackets. In this blog entry we will cover building the steer and shift tie rods, as well as assemble the shocks and axles. Everyone ready to move forward?...

Read More